电子琴程序设计与仿真顶层程序与仿真, 音阶发生器程序与仿真, 数控分频模块程序与仿真, 自动演奏模块程序与仿真设计例见随书所附光盘中文件: 电子琴 VHDL 程序与仿真。 1. 顶层程序与仿真(1) 顶层 VHDL 程序-- 文件名: top .vhd -- 功能: 顶层文件-- 最后修改日期: library IEEE; use ; use ; use ; entity top is Port ( clk32MH z :in std_logic; --32MHz 系统时钟 handTOauto : in std_logic; -- 键盘输入/ 自动演奏 code1 :out std_logic_vector(6 downto 0); -- 音符显示信号 index1 :in std_logic_vector(7 downto 0); -- 键盘输入信号 high1 :out std_logic; -- 高低音节信号 spkout :out std_logic); -- 音频信号 end top; architecture Behavioral of top ponent automusic Port ( clk :in std_logic; Auto: in std_logic; index2:in std_logic_vector(7 downto 0); index0 : out std_logic_vector(7 downto 0)); ponent; component tone Port ( index : in std_logic_vector(7 downto 0); code : out std_logic_vector(6 downto 0); high : out std_logic; tone0 : out integer range 0 to 2047); ponent; component speaker Port ( clk1 : in std_logic; tone1 : in integer range 0 to 2047; spks : out std_logic); ponent; signal tone2: integer range 0 to 2047; signal indx:std_logic_vector(7 downto 0); begin u0:automusic port map(clk=>clk32MHZ,index2=>index1,index0=>indx,Auto=>handtoAuto); u1: tone port map(index=>indx,tone0=>tone2,code=>code1,high=>high1); u2: speaker port map(clk1=>clk32MHZ,tone1=>tone2,spks=>spkout); end Behavioral; (2 )仿真顶层文件仿真图如图 所示。图 顶层文件仿真图 2. 音阶发生器程序与仿真(1)
817电子琴程序设计与仿真.doc 来自淘豆网www.taodocs.com转载请标明出处.