(2) After lifting the car, remove the oil drain plug and drain oil into a container. 5. Replace the oil filter. (1) Disconnect the oil filter cap from the oil filter body. (2) Remove the oil filter element. (3) Check and clean the oil filter installation surface. (4) Check the part number of a new oil filter is same as old one. (5) Install a new oil filter element (A) and new O-ring (B). (6) Apply clean engine oil to the new O-rings. Lightly screw the oil filter cap into place, and tighten it until the O-ring contacts the seat. (7) Finally tighten it again by specified tightening torque. Tightening torque : (, -ft) 6. Fill new engine oil. (1) Install the oil drain plug with a new gasket. Tightening torque : ~ ( ~ , ~ -ft) (2) Fill with new engine oil, after removing the engine oil level gauge. Capacity : Total : (, , ) Oil pan : (, , ) Drain and refill including oil filter : (, , ) ? Fill t he crankcase to about half the capacity and then fill the remainder after waiting. ? Do n ot fill oil over the 'F' line, checking the level with the oil level gauge. frequently to ensure no overfilling. (3) Install the oil filler cap and oil level gauge. 7. Start the engine and check to be sure no oil is leaking from the drain plug or oil filter. 8. Recheck the engine oil level. Inspection Reco mmendation : 5W-20 / GF&SM, 5W- 30 / AC EA A5 (If not available, refer to the mended ACEA, API or ILSAC classification) API classification : SL, SM or above ILSAC classification : GF3, GF4 or above ACEA Classification : A3, A5 or above SAE viscosity grade : Refer to the mended SAE viscosity number. 1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. 2. Check the engine oil level. After warming
2013年现代劳恩斯酷派GENESIS COUPE(BK)G3.8 GDI维修手册(二) 来自淘豆网www.taodocs.com转载请标明出处.