基于FPGA直流电机的PWM控制.doc

摘要如果采用 CPU 控制产生 PWM 信号,一般的 PWM 信号是通过模拟比较器产生的,比较器的一端按给定的参考电压,另一端接周期性线性增加的锯齿波电压。当锯齿波电压小于参考电压时输出低电平,当锯齿波电压大于参考电压时输出高电平。改变参考电压就可以改变 PWM 波形中高电平的宽度。若用单片机产生 PWM 信号波形,需要通过 D/A 转换器产生锯齿波电压和设置参考电压,通过外接模拟比较器输出 PWM 波形,因此外围电路比较复杂。 FPGA 中的数字 PWM 控制与一般的模拟 PWM 控制不同,用 FPGA 产生 PWM 波形,只需 FPGA 内部资源就可以实现。用数字比较器代替模拟比较器,数字比较器的一端接设定值计数器输出,另一端接线性递增计数器输出。当线性计数器的计数值小于设定值时输出低电平,当计数值大于设定值时输出高电平。与模拟控制相比,省去了外接的 D/A 转换器和模拟比较器,FPGA 外部连线很少,电路更加简单,便于控制。脉宽调制式细粉驱动电路的关键是脉宽调制,转速的波动随着 PWM 脉宽细分数的增大而减小。直流电机控制电路主要由三部分组成: FPGA 中PWM 脉宽调制信号产生电路。 FPGA 中的工作/停止控制和正/反转方向控制电路。由功率放大电路和 H桥组成的正反转功率驱动电路。关键词:直流电机脉宽调制 FPGA 数字比较器 FPGA-based DC motor control PWM II Abstract If the CPU control ofa PWM signal, the general PWM signal through the parator, compared with the end ofa given by the reference voltage, and the other termination cyclical linear increase in the sawtooth voltage. When the sawtooth voltage reference voltage output is less than low, when the sawtooth reference voltage greater than high-voltage output. Change the reference voltage can change the PWM waveform in the high-width. If the MCU have PWM signal waveform, through D/A converters have a sawtooth voltage and set reference voltage through an external parator output PWM waveform, the external circuit is plicated. The figures in the FPGA PWM control and the simulation of the general PWM control different, with a FPGA PWM waveform, just FPGA internal resources can be achieved. Compared with figures parison instead of analog, parison with the termination ofa set of counter output, and the other counter termination linear incremental output. When the linear counter less than the value of exports of low value set, when the set of values than high-value output. Compared with analog control, eliminating the external D/A converter and parator, FPGA few external connections, circuit more simple, easy control. PWM powder drive circuit, the key is PWM, with fluctuations in speed PWM pulse breakdown increased the number of decreases. . DC motor control circuits mainl