dell m1000e配置文档.doc

M1000e配置配置文档
第一部分:供电部分
PDU的规格如下图,连接如下。

机箱结构后视图。
经常DSP或者用户到电话进来,说按power 按钮无法开机,就是因为要等Enclosure加电之后,再按开机按钮才能生效。具体的信息如下,Enclosure is on Standby Power,Enclousure Power is ON,然后去按开机按钮,机器就能顺利启动了。具体的信息看下面的图片。


第二部分:CMC管理配置部分
CMC具体命令行:(配置的时候可以参考)
? <mand> -- display usage summary for a mand
arp -- display working arp table
chassisaction -- execute chassis or switch power-up/down/cycle or KVM powercy
cle
clrraclog -- clear the CMC log
clrsel -- clear the System Event Log (SEL)
hangeover -- Changes the redundant state of the CMC from active to standb
y and vice versa
config -- modify CMC configuration properties
deploy -- deploy blade by specifying required properties
feature -- display features active on the chassis/ feature deactivation
featurecard -- Feature card status and list the available features
fwupdate -- update the firmware on a CMC, server, IOM inf, or KVM
getassettag -- display asset tag
getchassisname -- get the chassisname
getconfig -- display CMC configuration properties
getdcinfo -- display general I/O module and DC misconfiguration informati
on
getflexaddr -- display the MAC addresses per slot/status of Flexa
all slots and fabrics
getioinfo -- display general IO information
getkvminfo -- display the KVM module information
getled -- display the LED settings on a module
getmacaddress -- get MAC/WWN addresses
getmodinfo -- get module configuration and status information
fg -- work settings for modules
getpbinfo -- get power budget status information
getpminfo -- get power management status information
getraclog -- display the CMC log
getractime -- display the current CMC time
getredundancymode -- gets the redundancy mode of the CMC
getsel -- display records from the System Event Log (SEL)
getsensorinfo -- display system sensors
getslotname -- gets the name of the slot in the chassis
getssninfo -- display session information
getsvctag -- display