（毕业论文）新庄湾联合站工艺设计(说明书、计算书).doc

摘要
新庄湾联合站位于甘肃省境内某干道一侧,该联合站拟建于一块大约是600m×400m的区域上优先征用。站址周围无大型企事业单位及大型建(构)筑物,距离矿场油库53公里。该地区地势较平坦开阔,土质为黄土。
站外来油经三相分离器、加热炉、油气分离器、电脱水器、稳定塔等首先进行油、气、水的分离,再经外输泵和计量间等向外输送。站内气体直接送往气体处理厂进行处理。
站内划分为油罐区,污水处理区,工艺区,配电区,消防区,辅助生产区,设计时设计了有泵流程,同时也考虑了停电流程,即使故流程。
根据任务书所给该站的处理量和各种设计参数,首先初步选择了各工艺段设备,接着确定了总平面布置和联合站的工艺流程。完成了站内的水力、热力计算以及三相分离器、油气分离器、电脱水器、加热炉的选型和校核,并进行了罐区计算,选取了浮顶油罐;接下来绘制了联合站平面布置图,联合站工艺流程图;之后又进行了站内管线的选取,以及外输泵和脱水泵的选取。最后设计并画了阀组间安装图。
关键词:联合站;油气分离;工艺流程;平面布置;泵房安装
Abstract
The Central Treating Station of Xin Zhuangwan is located in Bay Village in Gansu Province, a main road side, the Central Treating Station on a proposed approximately 600m × 400m area on a priority acquisition. Around the site to non-large-scale enterprises and large-scale building (structure) building materials, oil depot 53 kilometers from the mine. Relatively flat topography of the area open, for the loess soil.
The central treating station treats well stream. Its main task is oil, gas and water separation. Gas, crude oil and water mixture flow into the central treating station. First, it goes into three phase separators, then goes through fluid jacket heaters, Two phase separators, electronic dehydrators, stabilization tower ,at last treated crude oil is pumped to the mineral terminal.
According to the mandate given by the book about treatment capacity and a variety of design parameters, the initial choice between the first paragraphs of various process equipment, and then identified the general layout and the joint station process. Meanwhile, pletion of the joint station general layout diagram and flow chart of a joint station, designed and painted a valve between the installation diagram.
Key words: Central Treating Station; oil and gas separation; process; plan layout;
Pumping Station Installation
目录
第一章绪论 1
联合站设计的目的和意义 1
国内外研究现状 2
研究目标和研究内容 7
研究目标 7
研究的主要内容 7
研究方案 8
第二章联合站设计说明书 10
概述 10
简介 10
联合站工艺系统概述 11
设计基础数据 12
12