项目产品名称及型号单位数量单价金额备注1PCS-100 断刀检测系统套1品牌:PMT日本合 计货期 2-3 周VMP-23A 友佳立式加工中心断刀检测系统机床品牌:友佳机床型号:VMP-23A操作系统:法兰克刀库形式: PCS-100 断刀检测系统包含:控制单元线缆(可选)探头探针具体参数PCS-100断刀检测器破损检测器破损检测系统探针摆动摆动角度 5-175°电机驱动直接驱动式直流电机工作电压直流 24V最大电流250mA运行温度0-55℃l Uni-body Design for Ultimate Sealing一体成型机身工艺,高密封设计l Shaft-Direct Drive (Without Gear Box)轴直接驱动式,不带齿轮箱l Set Bolt固定螺栓l Adjust Ring for Swing Angle旋角调整环l V Cup SealV 型密封l Needle Cap (To be mounted or removed by the set screw)针帽,可通过固定螺丝进行装卸l Needle Length Std: 140mm Long Needle: 200mm ,标准:140mm,最大:200mml Flat Wand (Option) 110mm (L) 3mm (W)防护杆(选装),长 110mm,宽 3mml Carbide deposited针表面超硬化处理1. Contact Sensor PCS-100 with Needle Assembly接触式传感器/探头 PCS-100 以及探针配套装置Contact sensor PCS-100l Rotation angle can be set and/or changed flexibly CW W, in the range of 5° to175°.可通过设置或者更改旋转方向来调整旋转角度,调整范围为 5°到 175°.Setting CW W on the control unit depends on where the sensor/needle is set, andwhich one could achieve the nearest contact to the ,并据传感器探针的位置和就近被测工具的原则来调整旋转方向l Contact pressure of needle (speed of needle swing) can be changed in 3 steps by theswitch of control unit. The lowest swing speed is ideal for the small dia. of tools. Up toabout dia. of tools can be (探针旋转速度),最低旋转速度适合测小尺寸的被测工具,最小测量工具尺寸为 。l Swing speed of the needle can be selected in several steps. It can help to minimize thecycle time of ,这样能有效地缩短机器加工周期2. Control Unit SCU-100SCU-100 控制单元OK outputIf a tool is detected, OK relay outputs a momentary or latch signal. Green LED ,继电输出一个瞬间信号,绿 LED 灯亮起。FAULT outputWhen a broken tool condition is detected, FAULT relay outputs a momentary or latch signalRed LED ,瞬间发出一个故障信号,红色 LED 灯亮起System FaultA system Fault signal outputs at Fault relay when在以下情况会发出系统故障信号:l The sensor The sensor direction setting and the W switch setting are There is a short or disconne
友佳机床断刀检测设备方案书 来自淘豆网www.taodocs.com转载请标明出处.