F燃机启动调试步骤.docx

Day/Date 天 /m
Test试验
Purpose of Test 试验目的
Test activities 试验活动
Remarks 备注
Day 1
第1天
11/08/20
06
Rotor run^i n: 转子试
转：
Cra nk test 摇转试验
Listen for rubs or unusual noises
听是否有摩擦 和异常噪音
Functional test of emergency trip
butt on 紧急跳
闸按钮的功能试验
Purge speed cranking for
rotor vibratio n check 以
吹扫速度摇转，检查转子振动 情况
Monitor LCI starting temperatures and operation监视器LCI起动温 度和运行
Air blowing the purge
piping of D5 and PM4 gas fuel duri ng cra nk 摇转期
间给D5和PM4吹扫管鼓风
Check operation of lift
oil and tut ning gear 检
查顶轴油和盘车的运行
Roll up to 50 rpm trip by DCS emerge ncy push butt on and 200 rpm and trip by GT MK 6 con trol emerge ncy stop 通过 DCS 紧急按钮逐渐增加到50rpm,通过GT MK6控制紧急停机跳闸
Restart, accelerate to go to
Purge speed for 5min and select no rmal stop 重起，加速至U
吹扫速度5分钟，选择正常停止
Restart, hold at purge speed and air blow ing the pip ing
of D5 and PM4, t rip by DCS cus to met t rip (L4CT) after 30 Min crank test 重起, 保持
在吹扫速度，给D5和PM4管道鼓 风，在30分钟摇转试验后通过DCS 客户跳闸(L4CT)跳闸
Verify coast down to turning gear 核实 惰行至盘车
Monitor vibration levels through out the test period监视整个试验期间的振动 级
Use auto start^up seque nces to prepare the unit for a
Ready-to- Start米用自动走动顺序将 机组准备好“准备起动”
Rub checks are performed 检杳
摩擦
ADRE vibratio n mon itor to be conn ected 连接ADRE振动监视器 After Shut-dow n 停机后
Rein state the pip ing spool of D5 and PM4 pipe work after shutdown停机后重新恢复 D5和
PM5管子的导管
Day 1
Rotor
1. False fire 假点火
1. Select fire for false fire
After Shut-dow n 停•机i后
第1天
run"i n:
2. Actual First Fire to
and check unit for gas
1. In st all bala nee shots if required
11/08/20
转子试
FSNL
leaks, and P2 pt. Check 选
如果需要，安装平衡粒
06
转：
实际第一次点火至FSNL
择假点火的火，检查机组是否
2. Repair any leaks / defects ide n-
False
漏气，和P2。检查
tified修复发现的泄漏/缺陷
firin g,
2. Verify unit trip and coast
3. Replace or clea n the stra iners of
actual
dow n to tur ning gear 核实机
LP Hood spray, CEP, BFP and drains
first
组跳闸，惰行至盘车
spray and perform any other main te-
firing
3. Actual fir