毕业设计
基于单片机的车用数字仪表设计与实现
Design and Realization of Digital Instrument for Automobile based on MCU
: 王水润
: 本 科
: 电气与信息学院
: 电子信息工程
: 姜 航
: 讲 师
: 2009年6月16日
学生XX
学历层次
所在院系
所学专业
指导教师
教师职称
完成时间
长 春 工 程 学 院
摘要
本文以汽车现有电信号为基础,选配了霍尔传感器和数字式温度传感器DS18B20,以单片机AT89S52为核心,研制了一种汽车数字式电子组合仪表。仪表对车速、里程、油量、温度4个参数进行测量和显示。系统利用A/D转换器完成对油量信号的采集,车速脉冲信号由单片机进行处理,并由LED显示。随着汽车技术的发展,特别是近年来全球***系统(GPS)和在线故障诊断技术在汽车中广泛应用,原有的机械指针汽车仪表显示信息量小、体积大、测量误差大, 越来越无法满足使用的需要,数字式的汽车电子仪表成为发展的必然趋势。
关键词
单片机A/D转换器霍尔传感器 DS18B20LED
Abstract:
Digital electronic instrument is the inevitable the base of former electronic signal and appending a speed sensor, the DS18B20 which is a digital temperature sensor,this article designs a digital automobile instrument panel that uses microchip AT89S52 as its pletes the measurement and display of four parameters as follow:speed,journey,fuel and applies the A/D conversion inside microchip to measure the fuel signal, the microchip deal with the signal of vehicle speed and display the result with LED. With the development of vehicle technology, especially global position system and online fault diagnosis are adopted in automobile former mechanism pointer instruments havelots of limitations such as little information,large volume and low measurement precision,and can’t be used well today.
Keyword:microchipA/D conversionspeed sensorDS18B20 LED
目 录
1引言- 4 -
2总体方案设计- 5 -
- 5 -
设计容- 7 -
- 7 -
3硬件系统设计- 8 -
- 8 -
- 8 -
- 9 -
- 12 -
- 14 -
- 17 -
主控单元- 17 -
4软件系统的设计- 22 -
- 22 -
- 24 -
- 25 -
- 25 -
基于单片机的车用数字仪表设计论文 来自淘豆网www.taodocs.com转载请标明出处.