(Excellent handout training template)
博科交换机配置指导手册
Agenda
Session One Layer 2 Switches
Administration Essentials: Connection, command line and GUI essentials
Network Configuration: Default VLAN, VLANs Trunks and LAG
Redundant Connections: Spanning tree, RSTP, MSTP
Base Layer 3: VE’s and VLANs, Routing Ports, Static Routes
Session Two Layer 3 Switches
Dynamic Routing: RIP and OSPF
Redundant Routing interfaces: VRRP and VRRP-E
ISP Border routing: BGP
Traffic Control: ACL’s
Additional Slides
Additional Theory Slides (If required)
Additional Material useful for some students but outside the BCNE subjects (eg Rate-Limiting)
THANK YOU
Section
Layer 2 Switches
Administration Essentials
DB-9 male interface.
VT-100 terminal - straight-through cable
(female to female not a null-modem).
The VT-100 configuration is: 9600 Baud 8 Data Bits Parity = None Stop Bits = 1 Flow Control = None
For MODEM Cross-Over cable
(typically a DB-9F to DB-9F cable)
Console Port
SW-FastIron> enable
No password has been assigned yet...
SW-FastIron# show chassis
SW-FastIron# configure terminalSW-FastIron(config)# show chassis
Interface Level
Fixed Configuration products specify the Port number (FastIron Simulator)
SW-FastIron(config)# int eth 1 (eth 1 = ethernet port #1)SW-FastIron(config-if-1)#
Chassis products specify the Slot/Port (BigIron Simulator)
SW-FastIron(config)# int eth 2/1 (eth 2/1 = Chassis slot #2, ethernet port #1)
Stackable products specify the Stack-Number/Unit-Number/Port
SW-FastIron(config)# int eth 1/2/1 (eth 1/2/1 = Stack-number #1, Unit-number #2, ethernet port #1)
CLI Basics (Part 1 / 2)
Move back up the menu tree using “exit”
SW-ServerIron(config-rs-c1)# exit
SW-ServerIron(config)# exit
SW-ServerIron# exit
SW-ServerIron>
Use “end” or Cntl-Z to return to “#” prompt
Display the running-config and saved startup-config
SW-ServerIron# write terminal
SW-ServerIron# show running-config
SW-ServerIron# sh
《博科交换机配置指导手册》课件PPT模板 来自淘豆网www.taodocs.com转载请标明出处.