HAPSITEER高级操作培训
AutoTune 自动调谐
AutoTune can be initialized by: 自动调谐可由下列动作 Tune is open 注: 在打开手动调谐的同时, 消耗 NEG
Base Peak Gain (BPG) 基峰增益 (BPG)
BPG is related to the intensity of mass 117 BPG 与 M 117 的强度有关
BPG influences sensitivity BPG 影响灵敏度
ER ideal setting is ER 理想的设定值为
Range is to 范围为 至
Smart Plus ideal setting is Smart Plus理想的设定值为
Range is to 范围为 至
Adjusting Base Peak Gain调整基峰增益
The BPG is adjusted using EM (Electron Multiplier) voltage 用 EM (电子倍增器) 电压调整 BPG
Adjust using increments of 25 V 用增量 25 伏调整
The normal operating range is 1000 to 2000 volts 常规工作范围为 1000 至 2000 伏
Adjusting Base Peak Gain (BPG)调整基峰增益 (BPG)
Adjusted Base Peak Gain for an ER
为 ER 调整基峰增益
Real Time Mass Calibration Table实时质量校准表
Red boxes may be present in the Real Time Mass Calibration Area 在实时质量校准区可出现红色框
This indicates that resolution and/or intensity of the mass is out of range 这表明质量数的分辨率和/或强度已超出范围
Status Column 状态栏
Status Column will read OK, OK Low, OK High, Low or High
状态栏将出现 OK, OK 低, OK 高, 低 或 高等读值
High and Low are not acceptable 高和低是不可接受的
Mass Alignment 质量对准
Perform a Mass Alignment by pressing F5 按 F5 执行质量对准
Updates the Status column readings 更新状态栏读值
Perform a Mass Alignment prior to and after making adjustments to the tune parameters 调整调谐参数前和后执行质量对准
Target Resolution 靶分辨率
Resolution refers to the width of the mass 分辨率与质量数的宽度有关
The mass width should be 1 AMU 质量数宽度应为 1 AMU
The range for the Target Resolution is and 靶分辨率的范围在 至 之间
Adjusting Target Resolution 调整靶分辨率
Adjust in increments of 调整的增量为
The number in the Actual Percentage column is affected by the target resolution adjustments 实际百分数栏的数受靶分辨
HAPSITEER高级操作培训 来自淘豆网www.taodocs.com转载请标明出处.