slc500通讯设置步骤
D
2
3
4
在 Rslinx 软件窗体菜单条中选择 Communications 中的 Configure Drivers(图 3·2)。
图 3·2
在 Configure Drivers 窗体(图 3·3)的 Available Drivers 对话框中选择 Ethernet to
PLC-5 or 5820-EI à 点击 Add new à进入 Add New Rslinx Driver 对话框。
5
图 3·3
在 Add New Rslinx Driver 对话框(图 3·4)中用户指定的设备名称(一般缺省既 可),点击 OK,进入 Configure Driver for Ethernet to PLC-5 or 5820-EI 窗体。
图 3·4
6
在 Configure Driver for Ethernet to PLC-5 or 5820-EI 窗体(图 3·5)中,用户必须 指定 SLC 的 IP 地址,以便在以太网 SLC 和计算机之间进行通信,填好 IP 地址后,点击 Accept;再填写计算机的 IP 地址,点击 Accept, 点击 OK。
返回 Configure Drivers 窗体,在 Configured Drivers 对话框中看到 AB_ETH-1 A-B
Ethernet RUNNING(图 3·6)。
7
图 3·5
8
图 3·6
在 Configure Drivers 窗体的 Available Drivers 对话框中选择 RS-232 DF1 Devices à
点击 Add new à进入 Configure Allen-Bradley DF1 Communications Device 对话框(图
3·7)。
图 3·7
9
在 Comm Port 中选择串口电缆所连接计算机的串口号,在 Device 中必须选择
SLC-CH0/Micro/PanelView,然后点击 Auto-Configure,在右框中会看到 Auto Configuration
Successful! 点击 OK。
返回 Configure Drivers 窗体,在 Configured Drivers 对话框中看到 AB_DF1-1 DH485 sta:0 com1: RUNNING(图 3·8),点击 Close。
图 3·8
返回 Rslinx 软件窗体看到两条网络 AB_DF-1,DH-485 和 AB_ETH-1,Ethernet。在
10
slc500通讯设置步骤 来自淘豆网www.taodocs.com转载请标明出处.