VTP+STP+三层交换(综合实验)实验主要内容::~5 VLAN1为管理VLAN,不用作用户VLAN。............../1和f0/channel端口f0/10、f0/11、f0/12、f0/13用来连接接入层的二层交换机。SW-3L-2的f0/24连接路由器,配置路由接口。二层交换机的端口分配F0/23~24连接三层交换机,配置Trunk(23连SW-3L-1,24连SW-3L-2)F0/1~20连接主机,平均划分给VLAN。配置过程:VTP配置两台三层为server其余二层均为clientSW-3L-1(config)#vtpdomaincainiaoSW-3L-1(config)#vtpmodeserverSW-3L-1(config)#vtppassword1234SW-3L-1(config)#vtpversion2SW-3L-1(config)#vtppruningSW-3L-2配置相同略SW-A(config)#vtpdomaincainiaoSW-A(config)#vtppassword1234SW-A(config)#vtpversion2SW-A(config)#vtppruningSW-A(config)#vtpmodeclientB、C、D配置相同略添加VLAN,划入端口的配置略(按事先规划好的配置)STP配置SW-3L-1(config)#spanning-treevlan2rootprimarySW-3L-1(config)#spanning-treevlan3rootprimarySW-3L-2(config)#spanning-treevlan4priority4096SW-3L-2(config)#spanning-treevlan5priority4096//让SW-3L-1成为VLAN2、VLAN3的根网桥,SW-3L-2成为VLAN4、VLAN5的根网桥,实现负载分担。SW-A(config)#spanning-treeuplinkfastSW-A(config)#intf0/23SW-A(config-if)#spanning-treeportfastSW-A(config)#intf0/24SW-A(config-if)#spanning-treeportfast//配置上行速链路和速端口B、C、D配置略三层交换机的配置SW-3L-1(config)#iprouti
VTP STP 三层交换(综合实验) 来自淘豆网www.taodocs.com转载请标明出处.