博科交换机配置指导手册资料.ppt

FastTrack Training For Internal Use Only ? 2009 munications Systems, Inc. All Rights Reserved. 2 Agenda ? Session One Layer 2 Switches – Administration Essentials: Connection, command line and GUI essentials – Network Configuration: Default VLAN, VLANs Trunks and LAG – Redundant Connections: Spanning tree, RSTP, MSTP – Base Layer 3: VE ’ s and VLANs, Routing Ports, Static Routes ? Session Two Layer 3 Switches – Dynamic Routing: RIP and OSPF – Redundant Routing interfaces: VRRP and VRRP-E – ISP Border routing: BGP – Traffic Control: ACL ’s? Additional Slides – Additional Theory Slides (If required) – Additional Material useful for some students but outside the BCNE subjects (eg Rate-Limiting) THANK YOU Section Layer 2 Switches Administration Essentials For Internal Use Only ? 2009 munications Systems, Inc. All Rights Reserved. 4 – DB-9 male interface. – VT-100 terminal - straight-through cable (female to female not a null-modem). – The VT-100 configuration is: 9600 Baud 8 Data Bits Parity = None Stop Bits = 1 Flow Control = None – For MODEM Cross-Over cable (typically a DB-9F to DB-9F cable) Console Port For Internal Use Only ? 2009 munications Systems, Inc. All Rights Reserved. 5 SW-FastIron> enable No password has been assigned yet... SW-FastIron# show chassis SW-FastIron# configure terminal SW-FastIron(config)# show chassis Interface Level Fixed Configuration products specify the Port number (FastIron Simulator) SW-FastIron(config)# int eth 1 (eth 1 = port #1) SW-FastIron(config-if-1)# Chassis products specify the Slot/Port (BigIron Simulator) SW-FastIron(config)# int eth 2/1 (eth 2/1 = Chassis slot #2, port #1) Stackable products specify the Stack-Number/Unit-Number/Port SW-FastIron(config)# int eth 1/2/1 (eth 1/2/1 = Stack-number #1, Unit-number #2, port #1) CLI Basics (Part 1 / 2) For Internal Use Only ? 2009 munications Systems, Inc. All Rights Reserved. 6 Move back up the menu tree using “ exit ” SW-ServerIron(