附和导线平差程序[QBASIC].doc

学****文档 仅供参考
附和导线平差程序[QBASIC]
由本人在网络上收集整理
DECLARE FUNCTION DEG! (X!)
DECLARE FUNCTION DMS! (XX!)
DECLARE FUNCTION XCHABS(F1) <= F0 THEN
PRINT "导线方位角闭合差 F1= "; XCHAR$(DMS(F1), 6); " OK!"
ELSE
PRINT "导线方位角闭合差 F1= "; XCHAR$(DMS(F1), 6); " OVER LIMIT!"
END IF
PRINT "相对闭合差:"
PRINT TAB(5); "F3="; F3, "F4="; F4, "F="; F, "K=1/"; S / F
PRINT "改正后方位角:"
FOR I = 0 TO N - 1
PRINT TAB(5); "A("; I; ")="; XCHAR$(DMS(A(I)), 6)
NEXT I
PRINT "改正后坐标:"
FOR I = 0 TO M
PRINT TAB(5); "X("; I; ")="; XCHAR$(X(I), 4), TAB(30); "Y("; I; ")="; XCHAR$(Y(I), 4)
NEXT I
PRINT TAB(5); "X("; M; ")="; XCHAR$(X(M), 4), TAB(30); "Y("; M; ")="; XCHAR$(Y(M), 4)
学****文档 仅供参考
OPEN "" FOR OUTPUT AS #1
PRINT #1, " 导线平差"
PRINT #1, TAB(25); DATE$, TIME$
PRINT #1,
PRINT #1, "方位角允许闭合差 F0=+/-"; XCHAR$(DMS(F0), 6)
IF ABS(F1) <= F0 THEN
PRINT #1, "导线方位角闭合差 F1= "; XCHAR$(DMS(F1), 6); " OK!"
ELSE
PRINT #1, "导线方位角闭合差 F1= "; XCHAR$(DMS(F1), 6); " OVER LIMIT!"
END IF
PRINT #1, "相对闭合差:"
PRINT #1, TAB(5); "F3="; F3, "F4="; F4, "F="; F, "K=1/"; S / F
PRINT #1, "改正后方位角:"
FOR I = 0 TO N - 1
PRINT #1, TAB(5); "A("; I; ")="; XCHAR$(DMS(A(I)), 6)
NEXT I
PRINT #1, "改正后坐标:"
FOR I = 0 TO M
PRINT #1, TAB(5); "X("; I; ")="; XCHAR$(X(I), 4), TAB(30); "Y("; I; ")="; XCHAR$(Y(I), 4)
NEXT I
PRINT #1, TAB(5); "X("; M; ")="; XCHAR$(X(M), 4), TAB(30); "Y("; M; ")="; XCHAR$(Y(M), 4)
CLOSE #1
REM **********