以太网环保护交换协议(ERPS).ppt

 Ring Protection OverviewMarch, 2008ITU-T Q9 – SG 15
本资料由-大学生创业|创业|创业网料
在线代理|网页代理|代理网页| 减肥药排行榜|淘宝最好的减肥药|什么减肥药效果最好|减肥瘦身药|
Agenda
mendation Introduction
Objectives and Principles
Concepts
Protection Switching
R-APS Messages
Items Under Study
本资料由-大学生创业|创业|创业网料
在线代理|网页代理|代理网页| 减肥药排行榜|淘宝最好的减肥药|什么减肥药效果最好|减肥瘦身药|
2
ITU-T SG15/Q9 mendation
mendation consented February 2008
This mendation defines the APS protocol and protection switching mechanisms for ETH layer ring topologies. Included are details pertaining to bridged ring protection characteristics, architectures and the ring APS protocol.
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
DEC
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
NOV
DEC
JAN
FEB
MAR
2006
2007
2008
Proposals and Contributions
Converged Proposals
ERP Work Item Approved in ITU-T
Objective, Principles, and Requirements Setting
mendation Consent
本资料由-大学生创业|创业|创业网料
在线代理|网页代理|代理网页| 减肥药排行榜|淘宝最好的减肥药|什么减肥药效果最好|减肥瘦身药|
3
Objectives and Principles
Use of standard 802 MAC and OAM frames around the ring. Uses standard (and amended Q bridges), but with xSTP disabled.
Ring nodes supports standard FDB MAC learning, forwarding, flush behaviour and port blocking/unblocking mechanisms.
Prevents loops within the ring by blocking one of the links (either a pre-determined link or a failed link).
Monitoring of the ETH layer for discovery and identification of Signal Failure (SF) conditions.
Protection and recovery switching within 50 ms for typical rings.
munication for the protection mechanism should consume a very small percentage of total available bandwidth.
4
Terms and Concepts
Ring Protection Link (RPL) – Link designated by mechanism that is blocked during Idle state to prevent loop on Bridged ring
RPL Owner – Node connected to RPL that blocks traffic on RPL during Idle state and unblocks during Protect